|
|
|
Pro Shop Equipment
The tools of the trade can make all the difference a good ball and a great one. We use top of the line products to fit and drill your ball as well as keeping it in optimum performance.
Precision Ovalmatic System 3 Digital Drill Press
Able to drill any hole at any angle to any width utilizing 64ths bits and endmills; accurate to .0005". Utilizing a ball jig that locks the ball in place allows me to drill an extremely accurate span and pitch. Carbite tip drill bits make the hole true to size as well as using an assortment of end mills to create an oval precisely.
Able to drill any hole at any angle to any width utilizing 64ths bits and endmills; accurate to .0005". Utilizing a ball jig that locks the ball in place allows me to drill an extremely accurate span and pitch. Carbite tip drill bits make the hole true to size as well as using an assortment of end mills to create an oval precisely.
Storm Surface Factory Elite
- New Gear Box Assembly
- Improved Solenoid Design
- Updated Inductive Sensor Array
- Improved Ball Oscillation
- Redesigned Polish Pump Motor and Gear Box
- Updated Mainboard, Relay Board, and SMPS
- A Bright New Look
- Same Amazing Results
The Powerhouse Wave Machine
The ball is heated gradually to a safe and consistent temperature of 140 degrees, bringing the oil to the surface of the ball. The water moves around the ball in a circulating motion, and the force of the water, along with the Wave Solution, removes the oil from the surface, while keeping the plasticizer in the ball. A filter removes the oil from the water as the water recycles through the machine. A complete ball cleaning cycle lasts approximately 45 minutes, at which time a built-in radiator helps to cool the water back to room temperature.
The ball is heated gradually to a safe and consistent temperature of 140 degrees, bringing the oil to the surface of the ball. The water moves around the ball in a circulating motion, and the force of the water, along with the Wave Solution, removes the oil from the surface, while keeping the plasticizer in the ball. A filter removes the oil from the water as the water recycles through the machine. A complete ball cleaning cycle lasts approximately 45 minutes, at which time a built-in radiator helps to cool the water back to room temperature.
|
|
|
|